4 Data Recovery Tips from a Completely Dead Drive

Finding your precious disk drive dead can be a stressful and frustrating experience for most, as nobody wants to lose their valuable data. Imagine a scenario where you are knee-deep in work, irritated beyond belief, and then experience a drive failure all of a sudden.

Your frantic key pressing on your keyboard and slamming your machine does not help. Subsequently, panic mode is activated, and the situation is nothing less than a total nightmare. If you’ve ever experienced this, or want to avoid encountering a scenario like this, read on for a beneficial guide to get you out of this mess.

First and foremost, determine what exactly is wrong with your drive. After the diagnosis, we can proceed further with ssd drive data recovery. Usually, data loss occurs because of two prime factors, either software related or hardware malfunction. Distinguishing between the two is somewhat easy. You’d know you’re facing a hardware problem if you hear a clicking sound. If it’s a software problem, you’re in luck, as they are easy to counter.

However, there are certain tips and tricks that you can attempt in order to recover your precious data.

Try Data Recovery Software

Lucky for you, there’s a wide range of data recovery software that is designed specially to help in cases like these. Firstly, it requires you to switch the power off of the machine that is connected to the concerned drive. Once your machine stops running and your drive is marked safe, go ahead and make a clone of it. This is done so that ssd drive recovery can be carried out on the clone of the drive. When the cloning process is done, scan the clone with different recovery programs that you’ll easily find online. Some of them are free, while some effective ones need a few bucks to work.

Replace The PCB

When you find that your drive isn’t making any clicking sounds or any sounds for that matter, it means that it isn’t spinning at all. In this case, you will need to replace the Printed Circuit Board (PCB), which is the green circuit board attached to the bottom of the drive, with a matching one from another drive of the same kind. There are several DIYs explaining this, but leave it in the hands of a professional if you’re nervous.

Use Free BIOS Accessing Utilities

If your drive is detected by the computer but hangs when it is accessed, then it is a case of a large number of bad sectors. You will need to use utilities that can access BIOS, which can skip bad sectors and identify the data for you.

Consult a Specialist

If you’re finding it hard to wait for a miracle, or you don’t mind spending a bit of extra cash, now’s the time to seek help from a professional. Some reputable firms have employees who specialize in ssd drive recovery techniques and can do the job for you in a relevant environment. But you’re advised to do thorough research before handing in your personal device because after all, computers contain all of your life’s data and private information. Go with reputable recommendations and experienced professionals.

However, bear in mind that recovering lost data is like finding your stolen car. There’s no guarantee, but you can even find diamonds in the rough if you try hard enough.

Leave a Reply

Your email address will not be published. Required fields are marked *